Table of Contents
Advertisement
E-025-2-E
③ Click "OK" after the setting is completed to display the message box (Fig. 58). Click "OK" here to
change the settings to the inputted values.
④ The message box (Fig. 59) is displayed after changing the setting values. Click "OK" to complete
the setting process.
⑤ The window for setting item is displayed. To exit, click "Cancel".
3.6.7 Other Settings (Other)
3.6.7.1 Display Setting (Display setting)
① Click "Setup (S)" from the menu, and select "Display setting" from the drop-down list of "Other",
then the following window (Fig. 60) will be displayed.
② Select for respective items.
Setting item
Flow rate decimal
Total flow decimal
Variables display
cycle
Back light set
2
Number of digits following decimal point of LCD
actual flow display (Select from the right column.)
Number of digits following decimal point of LCD
total flow display (Select from the right column.)
Update interval of displaying LCD variables
(Select from the right column.)
Setting LCD backlight operation (Select from the
right column.)
Off: Backlight Off at all times
On: Backlight On at all times
Auto: Automatically turns off without key
operation for 10 seconds after backlight is
turned on (turns on again with key
operation)
Fig.58
Fig.59
Fig.60
Detail
Setting range
Integer, 1st Decimal,
2nd Decimal, 3rd Decimal
Integer, 1st Decimal,
2nd Decimal, 3rd Decimal
100ms, 300ms, 500ms,
1000ms
Off, On, Auto
Advertisement
Table of Contents
