Table of Contents
Advertisement
3.6.1 Flow Rate Parameter (Flow parameter)
3.6.1.1 Nominal Diameter (Nominal diameter)
① Click "Setup (S)" from the menu, and select "Nominal diameter" from the drop-down list of "Flow
parameter", then the following window (Fig. 27) will be displayed.
② Select the correct nominal diameter.
Setting item
Nominal diameter
③ Click "OK" after the setting is completed to display the message box (Fig. 28). Click "OK" here
to change the settings to the inputted values, and to reflect the changed setting values in the
flowmeter's output. If the flowmeter's output is used to control valves or other such parts as safety
protocol, change that control loop to manual control so that the control loop cannot be influenced
by the flowmeter's output.
④ The message box (Fig. 29) is displayed after changing the setting values. Click "OK" to complete
the setting process.
⑤ The window for setting item is displayed. To exit, click "Cancel".
Detail
Nominal diameter of sensor
(Select from the right column.)
Fig.27
3mm, 4mm, 6mm, 8mm, 10mm, 15mm,
20mm, 25mm, 32mm, 40mm, 50mm,
65mm, 80mm, 100mm, 125mm, 150mm,
200mm
Fig.28
Fig.29
E-025-2-E
Setting range
Advertisement
Table of Contents
