Pulse Output (Pulse Output) - Oval EL 2310-0BE Series Instructions Manual

② Enter numeric values for respective items.
Setting item
Upper range value
Lower range value
Flow range
Minimum span
Low cut
Damp
③ Click "OK" after the setting is completed to display the message box (Fig. 37). Click "OK" here
to change the settings to the inputted values, and to reflect the changed setting values in the
flowmeter's output. If the flowmeter's output is used to control valves or other such parts as safety
protocol, change that control loop to manual control so that the control loop cannot be influenced
by the flowmeter's output.
④ The message box (Fig. 38) is displayed after changing the setting values. Click "OK" to complete
the setting process.
⑤ The window for setting item is displayed. To exit, click "Cancel".

3.6.3.2 Pulse Output (Pulse output)

① Click "Setup (S)" from the menu, and select "Pulse output" from the drop-down list of "Outputs",
then the following window (Fig. 39) will be displayed.
Detail
Sets 20mA output of analog output.
Sets 4mA output of analog output.
Metering range
Minimum span of 100% - 0% value of analog output
Low-cut value of analog output
Low-cut value for preventing pulse output
when flow rate is near 0%.
Time constant for analog output damping
Minimum span to Flow range
0.0 to (Flow range - Minimum span)
Only for reference
Only for reference
0.0 to 10.0%
0.0 to 200.0sec
Fig.37
Fig.38
Fig.39
E-025-2-E
Setting range
2