Table of Contents
Advertisement
3.7 Menu: Diag/Service (Checking and Adjustment)
"Diag/Service" can be used to diagnose the flowmeter transmitter, perform loop tests on each output,
adjust output values, reset cumulative totals, and calibrate sensor input.
Close all "Setup (S)" windows to enable checking and adjustment functions.
Also note that other than "Loop test", the "Diag/Service (T)" window cannot be displayed
simultaneously with multiple windows (other than "Totalizer control").
The actual screen is as shown in Fig. 69.
Diag/Service
Self diag
Loop test
Trim Analog
Totalizer control
Total flow set
Diag/Service Item Tree
Fig.69
Circuit voltage
Exciting coil/circuit
Measurement signal
Empty pipe
Fix Analog
Fix Pulse
Fix Status output
E-025-2-E
5
Advertisement
Table of Contents
