Removing And Installing Button Labels; Installing Labels In The Buttons Of The Matrix Switcher - Extron electronics DMS 1600 User Manual

Removing and Installing Button Labels

Figure
them out, write button information in each button area as desired, and put them in the
input or output button windows of the switcher. You can also create labels using the Button
Label Generator software (see

Installing Labels in the Buttons of the Matrix Switcher

Install new labels in the front panel buttons as follows:
1.
2.
3.
4.
5.
6.
7.
8.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
63, on page 110 provides strips of blank button labels. If desired, copy them or cut
"Matrix
Remove the button from the matrix switcher; use a small, flat bladed screwdriver such as
an Extron Tweeker to gently pry a button out from the front panel (see figure 62).
T E
Button
Cap
Pry the two
pieces apart.
Separate the two-
piece button here at
the corner.
Figure 62. Illuminated Button Label Replacement
Locate the notch in the corner of one side of the clear button cap.
Separate the white backing (diffuser) from the clear button cap (lens); insert the blade of
the small screwdriver into the corner notch and gently twist the blade.
Save the translucent, white diffuser, but remove the text/label insert from the
transparent button cap.
Insert the replacement button label into the button cap. Check for correct label
orientation.
Align the white diffuser plate with the cap. The bumps on the diffuser plate should be
aligned (top and bottom) with the notches on the clear button cap. Firmly snap it into
place.
Align the tabs on the base of the matrix switcher with the notches on the diffuser plate.
Gently, but firmly, press the reassembled button into place in the front panel of the
switcher.
Repeat steps 1 to 7 as needed to relabel other buttons.
DMS 1600 and DMS 3600 • Maintenance and Modifications
Software").
Base
X T
Diffuser
Button Label
109