Table of Contents
Advertisement
14.
15.
16.
17.
18.
19.
Removing and Installing Button Labels
Making Labels Using the Button-Label Generator Program
The Button Label Generator creates labels that you can place in the translucent covers of
the input and output selection buttons. You can create labels with names, alphanumeric
characters, or even color bitmaps for easy and intuitive input and output selection (see
Installing Labels in the Buttons
replacing the translucent covers).
Installing the Button Label Generator software
The Extron Button Label Generator is available on the Extron website, www.extron.com,
under the
download and install the program on your PC.
Connect the terminal lugs on the replacement cable to the terminal block inside the
matrix switcher power distribution box (see figure 46 on the next page).
Internal Wiring
110 VAC - Line 2
LINE
220 VAC - Neutral
External Wiring
200-240 VAC 20 Amp
Figure 46.
Power Connection and Cable and Ring Specifications
NOTE: Figure 46 also specifies the wire gauge and ring terminal and ground stud
sizes.
Replace the power distribution box cover and secure it in place with the screw removed
in step 6.
Replace the power distribution box in the matrix switcher and secure it in place with the
two screws removed in step 5.
Fasten the chassis ground strap to the ground stud with the nut removed in step 4.
Orient the fan assembly so that the fans are on the underside and the board power
connector is to the left. Align the board edges with the board guides in the cabinet and
slide the fan assembly into place.
Replace the lower panel and secure it in place with the 15 screws removed in step 2.
tab. Click the
Download
XTP II CrossPoint Series • Maintenance and Modifications
Chassis Ground
Ring Terminal
Stud Size: #10 / M5
Wire Range: 12 - 10 AWG / 4.1 - 6.0 mm2
on page 90 for the procedure for removing and
link (see figure 47 on the next page), and
Software
88
Advertisement
Table of Contents
