Extron electronics DMS 1600 User Manual page 81

7.
Connect a computer running Windows to the serial port, USB port, or LAN port of the
switcher (see "Installation" for more details).
8.
Start the Matrix Switchers Control Program and connect to the matrix switcher (see
"Starting the
9. Click >
Tools
If you are connected via the LAN port, the
appears (see figure 33) (see Ethernet-connected firmware upload below).
If you are connected via either serial port, the
(see figure 34 and
next page).
Ethernet-connected firmware upload
Figure 33.
Select Files Window
10.
Navigate to the folder where you saved the firmware upgrade file. Select the file.
NOTES:
•
•
11.
Click the
Open
firmware of the switcher. Click
A status window appears that advises that the upload
is in progress. The firmware upload to the
DMS matrix switcher may take a few minutes. When
the status window closes and the front panel button
indications on the switcher flash amber, green, red, and amber and then return to either
off or to background illumination, the upload is complete.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
program," steps 1 through 4, starting on page 65).
.
Update firmware
"Serial-port or USB-port-connected firmware
Valid firmware files must have the file extension
extension is not a firmware upgrade.
The original factory-installed firmware is permanently available on the
DMS matrix switcher. If the attempted firmware upload fails for any
reason, the switcher reverts to the factory-installed firmware.
button. The software advises you that you are about to reprogram the
OK to continue.
DMS 1600 and DMS 3600 • Matrix Software
Choose File to Upload
window appears
Firmware Loader
upload" on the
11
. Any other file
.S19
window
75