Safety Instructions FCC Class A Notice Safety Instructions • English Инструкция по технике This equipment has been tested and found to comply with the limits for a безопасности • Русский WARNING: This symbol, , when used on the product, is intended Class A digital device, pursuant to part 15 of the FCC rules.
Plug the attached dust caps into the optical transceivers when the fiber cable is unplugged. This section gives an overview of this guide and the DMS 1600, DMS 2000, DMS 3200, and DMS 3600 and describes their features. Topics that are covered include: •...
About the DMS Matrix Switchers Configurability The DMS matrix switchers are assembled from I/O boards. The DMS 1600, DMS 2000, DMS 3200, and DMS 3600 (see figure 1) are configurable matrix switchers that distribute DVI signals and DFX • The DMS 1600 can include up to four I/O boards.
The input numbers supported by the I/O board in slot 2 (locations 5 through 8) are as follows: A = 5, B = 6, C = 7, D = 8. DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Introduction DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Installation...
Removing and the switcher is running or while you power up the switcher. Installing a Power Supply Module (DMS 1600 and DMS 3600) See the DMS Series Matrix Switcher User Guide, available on the page 31 to replace the power supply).
If the password is not accepted, the Password prompt reappears. The Preset and View buttons blink twice to indicate the mode change. Release the buttons. DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Front Panel Operations DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control...
= Carriage return and line feed = Carriage return (no line feed) = Pipe (can be used interchangeably with the character) = Escape key (hex 1B) = Can be used interchangeable with the character DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control...
Command and Response Table for SIS Commands Command ASCII Command Response Additional Description (Host to Unit) (Unit to Host) NOTES: • Commands can be entered back-to-back in a string, with no spaces. For example: 1*1!02*02&003*003%. • The matrix switchers support 1-, 2-, and 3-digit numeric entries (1*1!, 02*02&, or 003*003%). Create ties NOTES: •...
Page 13
Command ASCII Command Response Additional Description (Host to Unit) (Unit to Host) EDID NOTE: In the commands below, the EDID data can come from either an active output or be set to a specified value. Assign EDID data to an input EDID EdidA = Input number...
Page 14
Command ASCII Command Response Additional Description (Host to Unit) (Unit to Host) Channel mute commands Channel mute Mute output (no signal is output). Channel unmute Unmute output (signal is output). Read channel mute 1 = mute on, 0 = mute off. Global channel mute Mute all outputs.
Command and Response Table for IP-Specific SIS Commands Command ASCII Command Response Additional Description (host to unit) (unit to host) IP and serial port setup EX1! X1!] Set IP address Default: 192.168.254.254 X1!] Read IP address EX1! X1!] Set subnet mask Default: 255.255.0.0 X1!] Read subnet mask...
If the window does not open automatically, run NOTE: Launch.exe from the DVD. Click the Software tab. Scroll to the Matrix Switchers program and click Install . Figure 10. Select Matrix Switchers Program DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control...
5 for the IP address change to take place. The response should show the new IP address, as shown in the following figure. DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control...
Enter the Matrix IP address in the Address field. NOTE: 192.168.254.254 is the factory-specified default value for this field. Figure 13. Downloaded Start-up Page DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control...
D (of the same group of connectors) is on the right. DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Maintenance and Modifications...
Remove and Install a Power Supply Module Gently pull on the handle to loosen the power supply from the backplane. DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Maintenance and Modifications DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Maintenance and Modifications...
O UT Removing and Installing a Fan (DMS 1600 and DMS 3600) The DMS 1600 has a single fan module. The DMS 3600 has two identical fan modules. If a fan fails, it should be replaced at the earliest opportunity.
Page 24
Extron Warranty Extron Electronics warrants this product against defects in materials and workmanship for a period of three years from the date of purchase. In the event of malfunction during the warranty period attributable directly to faulty workmanship and/or materials, Extron Electronics will, at its option, repair or replace said products or components, to whatever extent it shall deem necessary to restore said product to proper operating condition, provided that it is returned within the warranty period, with proof of purchase and...
Page 25
Extron USA Headquarters Extron Europe Extron India +800.3987.6673 (Inside Europe Only) 1800.3070.3777 (Inside India Only) +800.633.9876 (Inside USA/Canada Only) +31.33.453.4040 +91-80 3055.3777 +31.33.453.4050 FAX +91 80 3055 3737 FAX Extron USA - West Extron USA - East +1.714.491.1500 +1.919.850.1000 Extron Japan Extron China +1.714.491.1517 FAX +1.919.850.1001 FAX...
Need help?
Do you have a question about the DMS 1600 and is the answer not in the manual?
Questions and answers