Extron electronics DMS 1600 User Manual page 125

Video output— DMS 44 DVI and DMS 4o DVI output boards
Number/signal type ........................ 4 digital RGB single link DVI-D per output board
Connectors .................................... 4 female DVI-I (digital only) per output board
Re-clocking .................................... Automatic
Output cable length ....................... 50' (15.24 m) at 1920x1200 @ 48, 50, or 60 Hz; or 1080p
Peripheral device power ................. 250 mA per output
Control/remote — switcher host ports
Serial host control port ................... 1 bidirectional RS-232 or RS-422, rear panel 9-pin female D connector
Baud rate and protocol ................... 9600 (default), 19200, 38400, 115200 baud, adjustable; 8 data bits, 1 stop bit, no parity
Serial control pin configurations
9-pin female D connector
RS-232 ............................... 2 = Tx, 3 = Rx, 5 = GND
RS-422 ............................... 2 = Tx-, 3 = Rx-, 5 = GND, 7 = Rx+, 8 = Tx+
USB control ports ........................... 1 front panel female mini USB B
USB standards ................................ USB 2.0, low speed
Ethernet control port ...................... 1 RJ-45 female
Ethernet data rate (for network communication)
Ethernet protocol ........................... ARP, ICMP (ping), IP, TCP, DHCP, HTTP, SMTP, Telnet
Ethernet default settings ................ Link speed and duplex level = autodetected
Web server ..................................... Up to 200 simultaneous sessions
Program control ............................. Extron control/configuration program for Windows
General
Power: DMS 1600 .......................... 1 or 2 (positive-negative), 100 VAC to 240 VAC, 50-60 Hz; internal, 175 watts each
Power consumption: DMS 1600 .....
Power: DMS 3600 .......................... 2*(positive-negative), 100 VAC to 240 VAC, 50-60 Hz; internal, 400 watts each
Power consumption: DMS 3600 .....
Power consumption: I/O boards ......
Temperature/humidity .................... Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Cooling .......................................... Fan, right to left (as viewed from front panel)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
10/100Base-T, half/full duplex with autodetect
IP address = 192.168.254.254
Subnet mask = 255.255.0.0
Default gateway = 0.0.0.0
DHCP = off
7.0 MB nonvolatile user memory
Extron Simple Instruction Set
™
Microsoft Internet Explorer ver. 6 or higher, Telnet
® ®
* A redundant power supply is optional.
Primary Power Supply Only Primary and Redundant Supplies
115 VAC, 60 Hz 240 VAC, 50 Hz 115 VAC, 60 Hz
97 watts 93 watts 107 watts
Measured fully loaded with (4) 4x4 I/O boards
*A redundant power supply is standard.
Primary and Redundant Supplies
115 VAC, 60 Hz
212 watts
Measured fully loaded with (9) 4x4 I/O boards
Per DMS Board
Board 115 VAC, 60 Hz 240 VAC, 50 Hz
4x4 I/O 18 watts
4 input 10 watts
4 output 7 watts
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
DMS 1600 and DMS 3600 • Reference Information
®
(SIS )
™
240 VAC, 50 Hz
103 watts
240 VAC, 50 Hz
203 watts
17 watts
10 watts
6 watts
119