Extron electronics DMS 1600 User Manual page 71

Starting the program
1. To run the Matrix Switchers Control Program, click
Electronics
The Comm Port Selection window (see figure 24) appears.
Figure 24. Comm Port Selection Window
2.
Choose either the comm port that is connected to the serial port of the switcher,
, or
IP [LAN]
•
If you selected a comm port, check the baud rate displayed in
the Baud Rate field. If you need to change the baud rate, click the
button and double-click on the desired baud rate.
Baud
Click OK . The Extron Matrix Switchers Control Program window
(see figure 26
configuration of the attached matrix. Proceed to
• If you selected
drop-down window and click
• If you selected
• If you selected
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
> >
Matrix Switchers MATRIX Switcher + Control Pgm
.
Emulate
and figure 27) appears, displaying the current
USB , select the DMS matrix switcher in the
. Proceed to
OK
and proceed to step 3.
, click
IP [LAN] OK
, click and see
Emulate OK
DMS 1600 and DMS 3600 • Matrix Software
> >
Start Programs Extron
"Using the program."
"Using the program."
"Using Emulation Mode" on page 83.
.
USB ,
65