Establishing A Telnet Connection - Comtrol DeviceMaster MOD Series Hardware Installation And Configuration Manual

Establishing a Telnet Connection

DeviceMaster MOD | UP Hardware Installation and Configuration Guide: 2000630 Rev. B
Use the following procedure to telnet to the DeviceMaster.
1. Open a telnet session, enter the DeviceMaster IP address.
If using Windows, you can use PortVision DX, see
Commands in Telnet/SSH Sessions (PortVision DX)
2. Press the Enter key if you did not program a password or type the password
and press Enter.
Note: The DeviceMaster does not come pre-programmed with a password.
3. Type reset, and close the session.
4. Open a new telnet session, enter the DeviceMaster IP address, and the
password.
5. Type dis to disable the Bootloader.
6. Verify that the system responds with a Loading disabled message.
RedBoot Procedures
Accessing RedBoot
on Page 68.
RedBoot Procedures - 73