Table of Contents
Advertisement
[13]
Remove the RESTRAINER from the
NON-DRIVE SIDE MAGNET SWING ARM.
[14]
Install the RESTRAINER on the DRIVE-SIDE
MAGNET SWING ARM.
[15]
Do steps 7 - 12 to check the non-drive side
ENTRANCE DETECTOR SWITCH. Align the
edge of the FILM TOOL with the non-drive
side of the FEED TRAY.
[16]
Remove the RESTRAINER.
Final Checkout
[17]
Insert the FILM TOOL into the center of the
DETECTOR CROSSOVER ASSEMBLY.
6-10
DETECTOR CROSSOVER
ASSEMBLY
Figure 6-9 Inserting the Film Tool
[18]
Check that ''Film detected'' is indicated on the
screen, as the FILM TOOL is inserted.
[19]
Remove the FILM TOOL from the
DETECTOR CROSSOVER ASSEMBLY.
[20]
Check that ''No film detected'' is indicated on
the screen.
[21]
If necessary, do the procedure again until the
ENTRANCE DETECTOR SWITCHES are
adjusted correctly.
[22]
Exit diagnostics.
[23]
Disconnect the portable computer.
[24]
Install the TOP COVER onto the processor.
FILM TOOL
H108_0167BCC
H108_0167BC
246616
Advertisement
Table of Contents
