Table of Contents
Advertisement
[4]
Remove the 4 SCREWS that hold the 2 BEARING SUPPORTS.
[5]
Remove the CHAIN from the MOTOR SPROCKET.
[6]
Remove the MAIN DRIVE SHAFT ASSEMBLY from the processor.
[7]
Remove the COLLAR from each end of the MAIN DRIVE SHAFT.
[8]
Remove the 2 BEARING SUPPORTS.
[9]
Install the 2 BEARING SUPPORTS onto the new MAIN DRIVE SHAFT.
[10]
Install all parts removed in previous steps.
BEARING
SUPPORT
SCREWS
246616
MAIN DRIVE
SHAFT
DRYER
DRIVE BELT
IDLERS
Figure 3-4 Removing the Main Drive Shaft
MOTOR SPROCKET
CHAIN
BEARING
SUPPORT
COLLAR
SCREW (2)
H108_0277BCA
H108_0277BA
3-7
Advertisement
Table of Contents
