Table of Contents
Advertisement
1
[3]
Loosen ⁄
rotation the 2 SCREWS that hold the DRYER DRIVE ASSEMBLY.
4
[4]
Energize the processor by moving the MAIN CIRCUIT BREAKER CB1 to the ''I'' position.
[5]
See the Operator Manual for the flowchart of menus leading to Diagnostics.
a.
If you have a PORTABLE COMPUTER, enter the Diagnostics Mode and energize the DRIVE
MOTOR.
b.
If you do not have a PORTABLE COMPUTER, and cannot enter the Diagnostics Mode—
• Remove the TOP COVER of the processor.
• Install a JUMPER into CONNECTOR P/J 29.
c.
Insert a sheet of unprocessed waste film into the FILM DETECTOR ASSEMBLY to activate the
transport system.
[6]
Adjust the 4 SETSCREWS in the DRYER DRIVE ASSEMBLY until the DRIVE BELT remains on the
center of the DRYER DRIVE ROLLER.
SCREW (2)
SETSCREW (4)
246616
The DRIVE BELT will track to the higher side of the ROLLER.
DRYER DRIVE
ASSEMBLY
Figure 4-15 Loosening the Dryer Drive Assembly
NOTE
H108_0240DCA
H108_0240DC
4-15
Advertisement
Table of Contents
