Kodak X-Omat 480 RA Service Manual page 83

[9] Place the FILM TOOL on the FEED TRAY with the FILM TAB on the drive side of the processor.
Do not allow the FILM TOOL to enter completely into the DETECTOR ROLLERS during the next step.
[10] Carefully guide the FILM TOOL until the TAB is between the DETECTOR ROLLERS and the HATCHED
SECTION of the FILM TOOL is under the FILM ACCUMULATOR LEDs.
[11] Fasten the TRAILING EDGE of the FILM TOOL to the FEED TRAY with adhesive tape.
246616
DETECTOR ROLLER
TAB FILM
ACCUMULATOR
LEDs
Figure 6-4 Using the Film Tool
FILM TOOL
ADHESIVE TAPE
FEED TRAY
HATCHED
SECTION
TRAILING EDGE
H108_0169DCB
H108_0169DC
6-5