Table of Contents
Advertisement
[7]
Wait for the DRYER to reach the correct operating temperature.
[8]
When the DRYER has reached the correct operating temperature, again check that the DRIVE BELT
remains on the center of the DRYER DRIVE ROLLER.
[9]
Tighten the 2 SCREWS loosened in step 3.
[10]
Again check that the DRIVE BELT tracks on the center of the DRYER DRIVE ROLLER. If it does not,
repeat steps 3, 6, and 9.
[11]
If you are currently in the Diagnostics Mode, exit Diagnostics.
[12]
Remove the JUMPER used in step 5 from CONNECTOR P/J 29.
[13]
Install all parts removed in previous steps.
4-16
IMPORTANT
Do not tighten the SCREWS too tight.
246616
Advertisement
Table of Contents
