Setup Gui - System - Software Update - junger T*AP Manual

set up GUI – SYSTEM – Software Update
The files to update the TAP will be available in ZIP format. You must unpack them to your PC in order to
access them for the update procedure.
You will find an image file for the TAP core system in the format : "rel_tap_x_y_z.img"
as well as update files for components, like the optional interface boards in the format :
"rsdi150_v47.sdi" or for Dolby CAT (OEM) modules or for the X*AP Remote Panel.
To update the Base Unit, you must <Browse ...>
Firmware File(which you have unzipped before) and press .
After finishing the procedure the device will reboot.
You may also update the firmware of an SDI board installed in one of the two interface
slots (or both). The example above shows one SDI I-O board installed into
interface 1 slot. You must select the appropriate file from the firmware update bundle (ZIP file)
and press
browser based set up – firmware update of the X*AP Remote Panel
You must open a browser and enter the IP address of the X*AP Remote Panel into the URL field :
afterwards.
for the respective
You must select the respective
file and press :
After finishing the procedure
the X*AP Remote Panel will
reboot and you must manually
reconnect the Base Unit you are
about to control.
22
T*AP