Base Unit Rear View - junger T*AP Manual

T*AP

Base Unit rear view

For fail safe operation the Base Unit provides two independent power supplies. These power supplies
operate in load balance. The status of both PS are displayed on the Base Unit front panel as well as on the
X*AP Remote Panel.
STATUS LED
INIT
LAN
USB
ISO-PWR LED
GPI
GPO
Interface 1
Interface 2
METADATA IN
METADATA OUT
SYNC IN
WCKL-OUT
AES IN 1/2 – 7/8
AES OUT 1/2 – 7/8
shows the status of the device controller
pressing the INIT button briefly will warm start the device controller.
Holding down the button until the STATUS LED flashes 3 times will initialize the
Base Unit to factory default
RJ45 socket for Ethernet connection to a LAN
USB 2.0 type B socket to connect the built in USB >> serial converter with an
external PC
lights up if the isolated 5V power supply for GPI /O application is turned on
25pin Sub-D female connector to interface with the 8 optical isolated general
purpose inputs
25pin Sub-D female connector to interface with the 8 switch over relay general
purpose outputs
slot to mount one of the optional interface boards (SDI, AES, analog)
slot to mount one of the optional interface boards (SDI, AES, analog)
9pin Sub-D female connector to receive and send Dolby® serial metadata
9pin Sub-D male connector to send Dolby® serial metadata
75Ohm BNC connector to connect with external sync sources
75Ohm BNC connector to synchronize external devices to the T*AP internal
word clock
AES3id inputs
AES3id outputs
5