Setup Gui - System - System Status - junger T*AP Manual

T*AP
setup GUI – SYSTEM – System Status
The System Status page provides a top level view of the various status information available for the device.
Device Status
Power 1
Power 2
Temperature
Sync Lock
Processing Status
Bypass
Upmix
Interface Status
AES I/O
SDI I/O Interface
Dolby Processing Status
Metadata
Decoder
Encoder 1
Encoder 2
provides the hardware status of the Base Unit
status of the first power supply (left hand side from rear)
status of second power supply (right hand side from rear)
measured on the surface of the main PCB
turns red if the external sync source is removed or unstable
turns red if Bypass is activated
turns green if Upmix is activated
turns red if an AES input that is internally in use (i.e you have routed it to
an input of a function block) has detected an error
turns red if the SDI input is not locked (no or bad SDI signal)
turns red if Metadata are not valid
turns red if the input signal is not Dolby encoded (PCM or corrupted)
status of the first encoder (if optional CAT561 is installed)
status of the D-E encoder (if optional CAT569 is installed)
status of the second encoder (if optional CAT561 is installed)
17