Table of Contents
Advertisement
setup GUI – EVENTS – Preset Events
The change of configurations and / or parameters of the T*AP is based on presets in general.
Each setup pane offers a set of 20 presets for the respective function block. See on page 21 :
"setup GUI – SYSTEM - the preset concept in detail".
Important Note! The Preset Events tab controls multiple preset categories which are represented by the
page embedded tabs. You must be aware that one trigger is valid for an entire line from System over
Routing to Audio Processor. If you change the Trigger on one of the embedded pages it will be valid for all
other pages.
setup GUI – EVENTS – Preset Events – System
On the SYSTEM > Setup pane you may change the program configurations manually or you may setup a
respective presets (surround). The Preset Event > System will later on load this one.
After selecting that preset the event manager reads the
program configuration from this preset and prints it right beside
The event manager now uses this program configuration for all other Preset Events sharing the same
event name.
Trigger
Event name
Setup
Program Configuration
setup GUI – EVENTS – Preset Events – Interfaces
The T*AP Base Unit has four AES I/Os and for example an optional SDI I/O interface is installed.
Therefore this pane offers two pull down boxes to select one of those preset for the respective interface
per event.
The "Change Prog Conf" as well as the "Dolby Fail" events do not change things for an interface.
I.e. the selection is empty "-".
when you click into the pull down box, you can select from one of the
previously defined triggers (e.g. Program Config).
It is advisable to give this "System Preset Event" a name
(e.g. Change Prog Config).
select one of the 20 presets from the SYSTEM > Setup menu
(e.g. "surround").
gives you an indication which mode the T*AP will be in when you load
that preset.
52
the selection box.
T*AP
Advertisement
Table of Contents
