Table of Contents
Advertisement
T*AP
setup GUI – AUDIO PROCESSOR – Input
Link
Input
Mute
Input Gain (dB)
Input HPF (Hz)
Input LPF (kHz)
Input Delay (ms)
enables the control of the respective column
will mute all channels controlled by the respective column
sets the gain [-80 ... +20]
high pass filter (6dB/oct) cut off frequency [OFF, 2, 20, 40, 80, 120]
low pass filter (6dB/oct) cut off frequency [OFF, 15, 20, 22]
[1 ... 2000]
35
defines the coupling of the control circuits in
order to maintain the listening balance for
correlated signals or to provide a grouping of
the setup parameters for multi channel
signals. To the left is an example that shows
the different link modes. This example
applies in general to all other link settings for
the T*AP.
Depending on the function block and the
control mode (ITU vs. EBU) the number of
possible link settings will differ.
Curves and dots of the same color indicate
the link condition.
Advertisement
Table of Contents
