Setup Gui - Audio Processor - Voice Over (4 X 2 Program Configuration) - junger T*AP Manual

T*AP
setup GUI – AUDIO PROCESSOR – Voice Over (4 x 2 program configuration)
Depending on the Program Configuration (SYSTEM > Setup > 5.1+2 or 4x2) the T*AP offers 2 or 4
voice over circuits. The example below shows a 4x2 program configuration :
The program signal path (e.g. 1L/1R) includes an attenuator to reduce the program level
and a node to mix the voice over signal with the respective program. As a source for the voice over signal
you may select either the adjacent program input 2L/2R or the AUX input. This allows you to build 2 fully
independent voice over paths or up to 4 voice over paths with a common voice signal driven from AUX
input.
Find below the parameter list for the example above :
43