Getting Started - Ip Setup Of The Base Unit - Via Web Browser - junger T*AP Manual

Hide thumbs Also See for T*AP:

Table of Contents

T*AP

getting started – IP setup of the Base Unit

* Read the default IP address printed on a label above the RJ45 Ethernet connector.

* Set up network parameters of the PC which meet the default IP address of the Base Unit

(net mask = 255.255.0.0).

* Connect the Base Unit with the PC either by an Ethernet cross over cable or by a switch.

* Open a browser and type IP address of the Base Unit into the URL field and press <ENTER>.

This will open the AUDIO PROCESSOR tab sheet of the GUI.

* Click on <SYSTEM> and the "Admin" tab will open automatically :

Enter the desired network configuration and press <apply>

Afterwards you must reboot the Base Unit in order to activate the new IP configuration.

Regarding Gateway address see above.

Important Note! After reboot neither the web browser nor the X*AP Remote Panel may be able to

communicate with the Base Unit. You must key in the new IP address in the URL field and change

the X*AP Remote Panel settings to attach this device again.

via web browser

–

Table of Contents