Setup Gui - Events - Action Events - Bypass Events - junger T*AP Manual

T*AP
setup GUI – EVENTS – Bypass Events
The T*AP has a dedicated <BYPASS> button on the X*AP Remote Panel. The function of this button may
be configured in the upper section of the Bypass Events pane.
You may lock the button
The top two rows of check boxes represent the bypass switches of the individual function blocks of the
DSP. They may be used to force the bypass function of individual blocks manually. The number of lines
(4 [4x2] or 2 [5.1+2] in this example) depends on the program configuration.
If you turn the <BYPASS> button of the X*AP Remote Panel ON the Processing Bypass check box will
show it. But you may also use the check box to turn the button ON / OFF.
In the lower rows you may configure the bypass function of the individual function blocks to be
controlled by an Bypass Events trigger :
The Event named "Bypass Event1" may be triggered by "Trigger 5". It will turn the bypass ON for the
function blocks: Expander, Compressor, and OFF for the Equalizer section.
and ou may also control it with the Processing Bypass check box :
55