Setup Gui - Audio Processor - Filter - Spectral Signature - junger T*AP Manual

Hide thumbs Also See for T*AP:

Table of Contents

setup GUI – AUDIO PROCESSOR – Filter – Spectral Signature

Spectral Signature is a dynamic multiband filter. It is rendered on the T*AP DSP :

To set up this application and to display the momentary behavior of it, you must run the Junger

Application Manager J*AP, in order to connect it with the program channels which are processed by

Spectral Signature. The application manager may be downloaded from the Junger website :

www.junger-audio.com/download/soft-firmware

You must enter the IP address of the device and press <Connect> afterwards. The Application

Manager will gather necessary information from the device and will display the IP address, the device

name and the programs including the channels which are used by the respective program.

If you highlight a program that is enabled for Spectral Signature the soft button

<Spectral Signature> becomes active.

Link

Spectral

Signature

Note

T*AP

defines the coupling of the

control circuits (see Input).

[Enable / Disable]

it must be enabled here in

order to run the filter.

each preset contains a

reference curve

- The Signature -

For each preset you may

attach a note to describe the

feature of that Signature

mask.

Table of Contents