Recall And Storage Of Presets; Software Version - junger Accent1 Operation Manual

5. OPERATION
GPI assignment
ACCENT has four GPI inputs for remote control. Following functions can be assigned to these
inputs (on if GPI input is switched to ground):
GPI is overwriting front panel settings.

Software version

display of software version
5.10
All individual settings for the signal processing and the status of the unit can be stored as presets.
99 presets are storable into the unit.
Adjustments are made by pushing and turning SELECT knob (see 5.1).
number of
selected preset
Load/recall procedure
PRESET
push
SELECT
turn
SELECT
push
SELECT
turn
SELECT
push
Push any other function button for leaving the preset menu without loading or recalling presets.
page 5-6 Operation manual accent2, chapter 5 -Operation-
preset 1, preset 2, preset 3, preset 4
bypass on, compressor on, limiter on,
expander on, filter on, reset (clip display)
D: dsp software
RECALL AND STORAGE OF PRESETS (preset button)
PR LOAD RECALL SAVE
20 ________________
LOAD is recalling the processing parameter only
(expander, filter, compressor, gain, limiter)
RECALL is recalling the processing parameter and
the status of the unit
(expander, filter, compressor, gain, limiter
and configuration, input and output setup,
link, display, fader setup, GPI and tally
assignment)
selection of PRESET menu
selection of LOAD or RECALL mode
switches to preset number selection
selection of preset number for loading or
recalling preset
executes loading or recalling of preset,
exit preset menu
C: controller software
preset name max.
16 characters