Setup Gui - System - Setup - junger T*AP Manual

setup GUI – SYSTEM – Setup
T*AP Program Configuration
Program Labels
T*AP Synchronization Source
setup GUI – SYSTEM - the preset concept in detail
The example above shows the preset concept of the T*AP. It is the central theme of the device.
For all relevant setting of the device one set of ON AIR parameters and 20 sets of PRESETS are available
If you want to load parameters from a preset or save parameters from the ON AIR area to a preset,
you must first select a preset number at the bottom of the ON AIR page.
You must press
Pressing will execute it. When you press
to overwrite the selected preset and to give it a (new) name.
acts as a clip board for the parameters of individual presets,
while will allow you to store / recall the set of 20 presets to / from the PC file system.
Important note! The presets of the T*AP are persistent by nature. You are working directly on the preset
memory, i.e. you must not worry about storing such presets. The T*AP does it for you.
here you may select between 5.1 + 2 and 4 x 2. This will
automatically configure all audio processing parts processors
each of the individual programs (two in 5.1 +2 and four in 4 x 2 has
a name that will be used as a reference for the display of
parameters and its setup.
with this pull down you may select between
the available sync sources :
Internal 48kHz, External AES, Input AES 1/2, External WCL,
Interface x (if an option board is installed Black Burst or TriLevel).
to open the pull down list to select the desired preset.
, you will be asked in a pop up :
20
T*AP