Table of Contents
Advertisement
V*AP
Setup GUI – SYSTEM – Firmware Update
The files to update the V*AP will be available in ZIP format. You must unpack them to your PC in order to
access them for the update procedure.
You will find an image file for the V*AP core system in the format : "rel_map_x_y_z.img"
as well as update files for components, like the optional interface boards in the format :
"rsdi150_v47.sdi" or for Dolby CAT (OEM) modules or for the X*AP RM
To update the V*AP, you must <Browse ...>
unzipped before) and press <start update>. After finishing the procedure the device will reboot.
You may also update the firmware of an SDI board installed into interface 1 (not seen in the example
above) or for an interface in the interface 2 slot if an update firmware is available.
Setup GUI – SYSTEM – Reboot
Restore Factory defaults
Overwrite Current IP
IP Configuration
to the respective Firmware File (which you have
Will clean up the parameter and preset memory and will initialize all
parameters to their factory default values and will reset passwords
and turn authentication off.
You may exclude the current IP settings from this process
to keep your local settings.
19
remote panel.
1
Advertisement
Table of Contents
