Getting Started - Ip Setup Of The X*Ap Remote Panel; Getting Started - Attach A Base Unit To A X*Ap Remote Panel - junger T*AP Manual

getting started – IP setup of the X*AP Remote Panel
By pressing the <MENU> button after power up or by pressing the red
you will enter the "T*AP X*AP Remote Panel Menu" page 1/3 to set up the IP configuration of the X*AP
Remote Panel and to attach up to 4 devices to this X*AP Remote Panel :
You may press
Here an example for the address field :
You must press one of the relevant <F-Keys> and that field will be highlighted as well as the Rotary Encoder.
Now you can change the value by turning the knob. When the setting of all fields is finished, you must press
<SAVE>. The display will return to the initial "T*AP X*AP Remote Panel Menu" page 1/3.
getting started – attach a Base Unit to a X*AP Remote Panel
You must press one of the "Device x" <F-Keys> and a different window will open :
Same procedure: Set up the IP address of the Base Unit you are about to attach.
You must turn "Show device in selection" to ON in order to reach the device via the initial display later on.
Pressing <SAVE> will return to the "T*AP X*AP Remote Panel Menu" page 1/3.
the relevant <F-Keys> and separate windows will appear for comfortable set up.
<ESC>
12
T*AP
button from the main display,