Setup Gui - Audio Processor - Filter - Equalizer - junger T*AP Manual

T*AP
program 4 (4L/4R)
MODE
Fail Threshold (dBFS)
Fail Wait (s)
Fail Return (s)
Side Chain Filter
setup GUI – AUDIO PROCESSOR – Filter - Equalizer
For the 4x2 program configuration similar applies
is fix connected to AUX.
[-80 ... -40]
RMS weighted input level for fail detection
[1.5 ... 10.0]
elapsed time after fail detection until the switch over will happen
[0.0 ... 10.0]
elapsed time after detection of a proper input signal until the switch
back to the program input
[OFF / ON]
a high pass filter (300 Hz) and a low pass filter (3000 Hz) is applied to
the detector side chain (not the audio path) to prevent hum and noise
from blocking fail over switching.
39
The Fail Over output can be permanently
connected to :
* its program input 1L/1R
* its adjacent program input 2L/2R
* or to the AUX input.
Automatic switch over in case of an input
failure may be configured for the AUX or the
adjacent 2L/2R input.
The filter section has two tabs.
The one on the left side allows the setting of
five parametric EQs :
Link defines the coupling of the
control circuits (see Input)
Equalizer [Enable / Disable]
Band 1
Filter Type [OFF, Lo Shelf, Peak,
Hi Shelf]
Frequency (Hz) [20 ... 2000]
Gain (dB) [-20 ... +20]
Q [0.4 ... 4.0]
Band 2 same as Band1
Band 3 same as Band1
Band 4 same as Band1
Band 5 same as Band1