Table of Contents
Advertisement
EASY LOUDNESS
Setup GUI – SYSTEM – Firmware Update
The files to update the EASY LOUDNESS will be available in ZIP format. You must unpack them to your
PC in order to use them for the update procedure. Here an example path name from the ZIP file:
junger_dap4_mei_firmware/base_unit_image
The folder /base_unit_image contains an image file for the EASY LOUDNESS core system in the format
(example):
"rel_dap4-mei_3_0_2-25852.img". The other folders contain update files for components, like the optional
interface boards in the format: "rsdi150_v51.sdi" or for the X*AP RM
xap_125105.img.
Important Note! After the update of the latest firmware image you must observe the Status messages
displayed in the middle below the firmware version of Interfaces x. If it indicates that you don't have the
latest firmware installed, you should select the respective file(s) via the drop down box and press the
<start update> soft button afterwards. But you can also upload an external file in case you need a
specialized version for any reason that is not contained in the uploaded firmware image.
Same applies to all interface boards.
In particular, if you have activated automatic update of option boards, you must secure power connection
during the update procedure. There is a potential risk of crashing the Dante board firmware when you lose
power during the module update (see interface description how to recover).
remote panel in the format:
1
19
To update the EASY
LOUDNESS, you must
<Browse ...> to find
the respective
firmware file (which
you have unzipped
before) and press
<start update>.
After finishing the
procedure the device
will automatically
reboot.
You may also update
the firmware of an
installed interface
(SDI or DANTE) in
slot 1.
Advertisement
Table of Contents
