Example Events Configuration - junger T*AP Manual

T*AP

Example EVENTS configuration

Finally an example for a field application. This shall demonstrate the steps which are needed to setup the
EVENTS system.
In Japan it is common practice to change the configuration of processing devices depending on additional
meta information. This meta information is standardized by the ARIB standard.
We will now demonstrate how to change the program configuration of the T*AP, controlled by such a meta
information received via SDI embedded ancillary data packets.
On the EVENTS > Trigger > Parameter Sources pane we define a parameter source :
To do so we have to look in the Category Interfaces for the Subcategory SDI I/O Interface1 and there for
the parameter ARIB B39 Audio Mode. The parameter expression "3/2+LFE (5.1)" will be the trigger
source. We give it the label : "ARIB audio status".
The next step is to configure the trigger :
We call the Trigger : "Program Config.". it is of the type Parameter and the source label
(defined in step one) is "ARIB audio status".
Now we must assign trigger to events. The trigger "Program Config." will launch the Preset Event
"Change Prog Conf" :
Finally we decide what shall happen if the example event "Change Prog Conf" becomes active. For our
example it will load the preset called "surround". When you have a look at the SYSTEM > Setup pane
you will see that the preset "surround" will reconfigured the T*AP to 5.1 + 2 program configuration :
In order not to get too complicated we will stop here. But you must keep in mind that the trigger
"Program Config" may also be used to change ROUTING paths and AUDIO PROCESSOR settings as
well as other things if it is appropriate.
56