Table of Contents
Advertisement
Setup GUI – SYSTEM – System Status
The system status is a special link you can reach independently from where you are:
The System Status page provides a top level view of the status information available for the device.
Device Status
Power 1
Power 2
Temperature
Sync Lock
NTP Server Status
Processing Status
Bypass
Interface Status
AES I/O
Interface 1 SDI I/O
System Messages
System Log
Provides the top level status of the EASY LOUDNESS.
The front panel STATUS LED is connected to this display.
Status of the first power supply (left hand side of rear panel).
Status of second power supply (to the right of the first power supply)
Measured on the surface of the main PCB.
Turns red if the external sync source is lost or unstable.
Is grey if the NTP server synchronization is turned off. It is green if the
clock is synchronized. It turns red if the clock can not be synchronized
via one of the NTP servers.
Turns red if general Bypass is activated. This can be turned on and off via
the X*AP remote panel only!
Turns red if an AES input that is internally in use (i.e you have routed it to
an input of a function block) has detected an error.
Turns red if an error occurs on the SDI interface.
[current / history]
Displays a list of messages produced by the system controller.
The system controller activities will be logged. This log information may be
downloaded from the device and sent to Junger Audio. In case of a
problem you can press: <save diagnostics file> from here or from:
SYSTEM > Admin > Diagnostics.
10
EASY LOUDNESS
Advertisement
Table of Contents
