Cycle Information - Kodak X-OMAT 7000 User Manual

Cycle Information

7E6174 – 16FEB01
3. Press DONE/RETURN until you return to the Processor Main Menu.
Note
The K/RA cycle is not available from this menu. Special chemicals and films are
required. This cycle may only be selected by a Kodak trained Key Operator and a
Kodak Service Representative.
Process Time
Cycle In Seconds
K/RA USA 48
K/RA 64
Outside
USA
Rapid 64
Standard 86
Cycle The film processing cycle that is currently selected.
Process Time The time it takes the leading edge of a 35 x 43 cm
(14 x 17 in.) sheet of film to move from the Entrance Rollers
to the Exit Rollers of the Dryer Rack.
Drop Time The time it takes the leading edge of a 35 x 43 cm
(14 x 17 in.) sheet of film, fed 43 cm wide, entering the
Entrance Rollers until the trailing edge exits the Dryer Rack.
Film and Chemicals For optimum image quality use KODAK Films in
combination with KODAK X-OMAT Developers and Fixers
or the equivalent.
NOTE: For the K/RA Cycle, contact your Kodak Service
Representative for film and chemistry recommendations.
Throughput The number of 35 x 43 cm (14 x 17 in.) sheets of film, fed
43 cm wide, that can be processed in 1 hour.
Changing from STD to RAPID requires approximately 5 minutes for the temperatures
to change and stabilize. From RAPID to STD requires approximately 15 minutes for
the temperatures to reduce.
The cycle will be shown on the Display Panel of the KODAK X-OMAT Multiloader
7000 (Multiloader).
Replenisher rates, speed, and temperatures are automatically adjusted for the chosen
cycle.
Drop Time In
Seconds Films and Chemicals
58 RA Films and RA
Chemicals
77 RA Films and RA
Chemicals
77 KODAK Films and
KODAK X-OMAT
Chemicals
105 KODAK Films and
KODAK X-OMAT
Chemicals
Operating Instructions
Throughput
Films/hour
270
201
148
148
4–3