Using The Access Code - Kodak X-OMAT 7000 User Manual

Key Operator Instructions

Using the Access Code

5–12
Only your Kodak Service Representative and Key Operator should have use of the
access code. The Key Operator receives the access code when trained by Kodak. Press
GO TO SETUP and enter the access code.
The access code is necessary to:
• change setup information preset at the factory
• change to or from the "K/RA" cycle
If the Limited Access Feature is off, an access code is not necessary to perform the
functions listed below:
• select Processor cycles (except "K/RA")
• change dryer temperature
• display fixer temperature
• place the Processor in the sleep mode
• display the time and the date
1. On the Processor Main Menu press PROC.
Status Lights
M A G. 1:
ON * M A G. 2:
GREEN
M A G. 3:
ORANGE M A G. 4:
M A G. 5:
M A G. 6:
RED
M A G. 7:
FUNC
Soft Switches
H186_8501AC
Screen 1 of the Processor Main Menu is displayed.
Note
All descriptions on the following pages start with this menu.
PROCESSOR READY
o
127 F = DRYER TEM
DRYER
TEMP
H186_8514AC
18 x 24 cm M
18 x 24 cm X
24 x 30 cm M
24 x 30 cm X
8 x 10 in V
35 x 43 cm X EMPTY
35 x 43 cm X #2 ?
UNLOAD LOAD SERIAL
o
95 F = DEV TEMP
SLEEP SELECT MORE
CYCLE
PROC
STD
DONE/
RETURN
16FEB01 – 7E6174