Comtech EF Data XPA-200 Installation And Operation Manual page 62

XPA200-7984-I-OPT1, X-Band SSPA
5.8.1.9 Equipment Type
Equipment Type is a command that retrieves the model number
and software version of the equipment.
cannot be changed by command.
Retrieve Equipment Type:
Confirmation:
xxxxxxx = Model Number
Example:
5.8.1.10 Application Identification
The Application Identification (AID) command allows a free
form message to be created.
the satellite, transponder, beam, destination or other aspects of
the application that may be significant to operations.
message length corresponds to capability of the LCD and is 48
characters in total.
therefore, blanks must be used after line 1 information in order
to space to line 2.
Trailing blanks will be generated to fill the LCD field.
display will alternate with the Equipment type display by use of
the clear function key on the front panel.
MESSAGE".
Application ID:
Confirmation:
Retrieve ID:
Confirmation:
Note:
XPA200-7984-I-OPT1, Rev.2
>DEV/RET_XPA200-7984-I SW_1.07
The second line begins at character 25,
A carriage return ends the command.
<DEV/AID_xxxxxxx ... xxxxx'cr'
>DEV/AID_'cr'
<DEV/AID_'cr'
>DEV/AID_'cr'
xxxxxxx ... xxxxx = Your message, maximum 48
characters.
<DEV/RET_'cr'
>DEV/RET_xxxxxxx yyyyy'cr''lf']
yyyyy = Software Version
It is intended to identify either
xxxxxxxxxxxxxxxxxxxxxxxx'cr'
xxxxxxxxxxxxxxxxxxxxxxxx'cr''lf']
xxxxxxxxxxxxxxxxxxxxxxxx'cr'
xxxxxxxxxxxxxxxxxxxxxxxx'cr''lf']
Remote Control Remote Control
The information
The
The default is "AID
The AID
5-10