Comtech EF Data XPA-200 Installation And Operation Manual page 39

XPA200-7984-I-OPT1, X-Band SSPA
3.3 Operation
Local operation of the 200 watt, X-Band SSPA is controlled by
operator input commands initiated through the six button key-pad on
the front panel.
control, configure and monitor the status of the SSPA.
inputs and commands entered into the key-pad are displayed by the
front panel twenty-four character, two line, LCD display.
5.0 for Remote Control Operation.
There are five operating command functions: Configuration,
Monitor Status, Currents Faults, Stored Faults and Utility Functions.
A flow chart for selecting the commands, operating menus, and data
inputs is shown in Figures 3-1 through 3-6.
ENTE R
--- ---- -- SE LECT ---- ---- -
--- - CON FIGU RATI ON - MEN U --
(S ee F igur e 3- 2)
- ---- ---- SELE CT ---- ---- -
- - MON ITOR - STA TUS - ME NU -- -
(S ee F igur e 3- 3)
---- ---- - SEL ECT --- ---- --
-- CU RREN T - FA ULTS - M ENU - --
(S ee F igur e 3- 4)
Figure 3-1.
XPA200-7984-I-OPT1, Rev.2
The key-pad is the local operator's interface to
--- - XPA 200- 7984 -I ---- -
SW VER 1.02 SN XXX
LEGEND
KEY-PAD
DISPLAY
SSPA Operating Command Functions
- ---- ---- SE LECT ---- ---- -
- -- STOR ED - F AULT S - ME NU
(S ee F igur e 3- 5)
--- ---- -- SELE CT -- ---- ---
- UT ILIT Y - FUNC TION S - ME NU -
(S ee F igur e 3- 6)
RIGH T
UP
LEFT
DOWN
--- ---- ---- ---- ---- ---- -
--- ---- ---- ---- ---- ---- -
System Operation
Operator
See Section
ENT ER
C LR
3-3