Table of Contents
Advertisement
BEFORE DIVING THE G3000SS DIVING HELMET, THE PROCEDURES IN THIS CHECKLIST MUST
BE COMPLETED, NORMALLY ON A DAILY BASIS (I.E. PRIOR TO THE FIRST DIVE OF THE DAY).
NOTE: The procedures in this checklist are to be performed only by personnel who
have received appropriate training in the operation of the G3000SS diving helmet.
WARNING: Aqua Lung strongly recommends completion of this checklist and
meeting the minimum requirements provided before using the G3000SS diving
helmet. However, these requirements are not conclusive, as further steps may be
required depending on the type of activity performed. FAILURE TO COMPLY WITH
THIS CHECKLIST MAY RESULT IN SERIOUS INJURY OR EVEN DEATH.
CAUTION: When using the G3000SS diving helmet, a correctly maintained and
serviceable Emergency Gas Supply (EGS) must be used. The EGS must include
a 1st stage regulator fitted with submersible pressure gauge and pressure relief
valve. The EGS must be confirmed as fully functional prior to diving.
NOTE: When using the EGS, during completion of the daily checklist, the first stage
regulator must have an intermediate pressure (IP) output set between 129 and 150
psig (8.9 - 10.3 BAR). In addition, the first stage regulator bleed/pressure relief valve
should be set between 180 and 200 psig (12.4 - 13.8 BAR).
COMPLETE THE FOLLOWING BOXES PRIOR TO THE CHECKLIST
COMPLETE THE SIGNATURE, DATE AND COMMENTS AT THE END OF THE CHECKLIST
Helmet Serial No:
Diver / Tender:
(Print Name)
CHECKLIST 1
G3000SS DIVING HELMET
DAILY CHECKLIST
Date:
11
Advertisement
Table of Contents
