78
Aqua Lung G3000SS Diving Helmet Operations & Maintenance Manual
Wiring Terminal Block for 2-Wire Communications
1. Install connector cable lug rings onto the terminal
block (83) per the terminal block pin configuration
(Fig. 14) and wiring diagram (Fig. 15). Install the
speakers left / right and microphone lug rings onto
the terminal block per the wiring diagram. Securely
tighten communication post hex nuts to terminal
Figure 14
block with a 3/8" nut driver.
CAUTION: DO NOT overtighten the communication post hex nuts to the terminal block.
Mic
Mic
Mic
Speaker
(right)
Speaker
Speaker
(right)
(right)
Speaker
(left)
Speaker
Speaker
Figure 15
(left)
(left)
2. Hi-Use pin configuration (Fig. 16) and Marsh Marine pin configuration (Fig. 17).
Figure 16
Figure 17