Checklist 3: G3000Ss Diving Helmet In-Water Checklist For Supervisor - Aqua Lung G3000SS Operation & Maintenance Manual

18
WHEN DIVING THE G3000SS DIVING HELMET, THE PROCEDURES IN THIS CHECKLIST
MUST BE COMPLETED.
WARNING: Aqua Lung strongly recommends completion of this checklist and
meeting the minimum requirements provided before using the G3000SS diving
helmet. However, these requirements are not conclusive, as further steps may be
required depending on the type of activity performed. FAILURE TO COMPLY WITH
THIS CHECKLIST MAY RESULT IN SERIOUS INJURY OR EVEN DEATH.
CAUTION: When using the G3000SS diving helmet, a correctly maintained and
serviceable Emergency Gas Supply (EGS) must be used. The EGS must include
a 1st stage regulator fitted with submersible pressure gauge and pressure relief
valve. The EGS must be confirmed as fully functional prior to diving.
WARNING: When diver uses less than the minimum recommended supply
pressure, the work must be adapted to prevent over-breathing the system,
which will result in exhaustion.
COMPLETE THE FOLLOWING BOXES PRIOR TO THE CHECKLIST
COMPLETE THE SIGNATURE, DATE AND COMMENTS AT THE END OF THE CHECKLIST
Helmet Serial No:
Diver/Tender:
(Print Name)
1. The diver must ensure the helmet is breathing and must report that breathing is satisfactory.
2. The diver must ensure the helmet is watertight and if wearing a dry-suit, the diver
must ensure no leakage occurs. Diver must report that a proper seal has been made.
Aqua Lung G3000SS Diving Helmet Operations & Maintenance Manual
CHECKLIST 3
G3000SS DIVING HELMET
IN-WATER CHECKLIST FOR SUPERVISOR
PROCEDURE
Date:
INITIALS