Table of Contents
Advertisement
ANNUAL INSPECTION AND MAINTENANCE CHECKLIST
Inspection and maintenance procedures in accordance with this checklist are to be conducted
annually (i.e. Annual Overhaul) unless daily or monthly inspections reveal the need for this to
be conducted more frequently.
This checklist is to be used in conjunction with the helmet Operations and Maintenance Manual
for guidance in conducting each step in the inspection and maintenance of the G3000SS.
NOTE:
•
The procedures in this checklist are to be performed only by personnel who
have received factory authorized training through an Aqua Lung Service
and Repair Seminar.
•
If you do not completely understand all of the procedures outlined in this checklist,
contact Aqua Lung to speak with a technical advisor before proceeding any further.
•
If the helmet is used in contaminated water, monthly inspection and maintenance
is required.
•
After completing this checklist, it should be kept in the helmet maintenance log/file.
WARNING: Aqua Lung strongly recommends completion of this checklist and
meeting the minimum requirements provided before using the G3000SS helmet.
However, these requirements are not conclusive, as further steps may be required
depending on the type of activity performed. FAILURE TO COMPLY WITH THIS
CHECKLIST MAY RESULT IN SERIOUS INJURY OR EVEN DEATH.
1. All parts replaced annually are contained in the annual service kit P/N 400180 (See Appendix R).
2. Any damage or defective parts must be replaced.
3. All parts should be cleaned using the standard procedures detailed in Appendix Q of the Operations and
Maintenance Manual.
TOOLS REQUIRED FOR ANNUAL MAINTENANCE
3/8" Nut Driver
7/16" Nut Driver
3/16" Allen/Hex Key
1/4" Allen/Hex Key
5/8"Flat OE Low Profile / Slim Wrench
11/16"Flat OE Low Profile / Slim Wrench
O-Ring Tool (Brass or plastic)
3/8" Flat Blade Screwdriver
CHECKLIST 6
G3000SS DIVING HELMET
GENERAL INSTRUCTIONS
5/16" Flat Blade Screwdriver (Regulator Adjust)
Phillips #3 Screwdriver
15/16" Deep Socket and Driver
11/16" Socket and Driver
7/8" Deep Socket and Driver
Torque Screwdriver (20 - 140 inch pounds)
Torque Wrench (10 - 40 foot pounds)
Additional tools for the Apeks GX300 Second Stage
Regulator are listed in t
GX300 REGULATOR FOR THE AQUA LUNG G3000SS
DIVING HELMET - MAINTENANCE MANUAL.
he separate Apeks document
51
Advertisement
Table of Contents
