Table Of Condition Number; Mode For Operating The Sewing Machine; Standard Input; Standard Output - Brother BAS H Series Instruction Manual

The following shows the output condition numbers, enabling condition numbers and disabling condition numbers, and
operations to establish them.

Mode for operating the sewing machine

Condition
Operation to establish the condition
No.
After a feed is complete at the home
1
position
After a feed is complete at the sewing
2
start point (at escape point, if applicable)
Before sewing or a test feed starts from
3
the sewing start point (or the escape
point)
Before the upper shaft of the sewing
4
machine starts rotating at the first stitch
5
Before a test feed starts at the first stitch
After sewing or a test is complete
6
(before moving to the sewing start or
escape point)
7
After an emergency stop is reset
8
After a step back starts
9
Before halfway sewing starts
After the lower thread counter value
10
changes from 1 to 0 and the lower thread
replacement wait state starts.
After the lower thread replacement wait
11
state ends
12
After a program starts
13
After a program ends
When trigger data is detected during
14
sewing
15
After an emergency stop occurs
16
After a thread breakage is detected
17
After a program is changed
18
After the power switch is turned on
19
After a low air pressure error is detected
Before moving to the next start point on
20
completion of sewing in the split mode
After moving to the next start point on
21
completion of sewing in the split mode
T a b l e o f c o n d i t i o n
T a b l e o f c o n d i t i o n

Standard input

Standard output

BAS H series, Programmer
CHAPTER 4 EXTENDED OPTION OUTPUT (PROGRAM)
n u m b e r
n u m b e r
Condition
Operation to establish the condition
No.
When the foot pedal is enabled (before the
25
work clamp moves up or down)
When the start pedal is enabled (before
26
starting operation)
Condition
Operation to establish the condition
No.
After the work clamp rises (after the right
30
work clamp rises for the air type)
31
After the work clamp lowers
After the left work clamp rises (only for
32
the air type)
After the left work clamp lowers (only for
33
the air type)
34
After the intermittent work clamp rises
35
After the intermittent work clamp lowers
36
After the wiper output is turned off
After the thread breaking output is turned
37
off
38
Before the work clamp rises
85