Adding A Sewing Point - Brother BAS H Series Instruction Manual

CHAPTER 3 PROGRAMMING PATTERNS

Adding a sewing point

1. .
Touch
2. .
Touch
3. Touch to set the skipping units (1, 10, 50,
100, 500, 1000, 5000), code display switching
(Hide code, Show code)、sewing point method for
appending (Add Manually, Add Automatically) and
method for moving the cursor (Move freely, Snap
to needle point).
* The method for moving the cursor is only displayed
when the sewing point method for appending is set to
"Add Manually".
■ Adding sewing points automatically
4. Touch to set the sewing point method for
appending to "Add Automatically".
5. Use to move the cursor
point where you would like to add a sewing point.
* You can move the cursor according to the skipping units.
* You can move the cursor continuously by holding down
the key.
44
6. Press
*
■ Adding sewing points manually
4. Touch
5. Use
Skipping units
* You can move the cursor according to the skipping units.
Code display
switching
* You can move the cursor continuously by holding down
Sewing point method
for appending
Method for moving
Press
6.
the cursor
* If the method for moving the cursor is set to "Move
* If the method for moving the cursor is set to "Snap to
Skipping units
Code display
switching
Sewing point method
7. Press
for appending
to the sewing
BAS H series, Programmer
.
The sewing point will be automatically added
between the selected sewing point and the next
sewing point.
to set the sewing point method for
appending to "Add Manually".
to move the cursor
point where you would like to add a sewing point.
the key.
once, and then use the jog key to
move the cursor to the place where you
would like to add the sewing point.
freely", the cursor can be moved to any desired
position.
needle point", the cursor will move to the sewing point.
.
*
The sewing point will be added in between the selected sewing
point and the next sewing point at the position where the
cursor was moved to in step 6.
Skipping units
Code display
switching
Sewing point method
for appending
Method for moving
the cursor
to the sewing