Programming Example; Programming For Each Stitch - Brother BAS H Series Instruction Manual

This section describes how to create a program, using an actual program as an example.
◆ Programming for each stitch: Page 51
◆ Pattern with lines: Page 52
◆ Pattern with curves: Page 53
◆ Double stitch and multiple stitch: Page 54
◆ Continuous sewing with the work clamp in
position after thread trimming(feed): Page 55
* For function and operating information about each icon, refer to "Programming" (page 22).
* In the programming example, point A in the illustration is the first stitch.

Programming for each stitch

The following describes how to perform programming for each stitch according to the pattern sheet.
1. Carry out steps 1 to 3 in "Programming procedure"
(page 17).
2. Touch .
3. Touch .
4. Use the jog key to move the cursor
P r o g r a m m i n g e x a
P r o g r a m m i n g e x a
◆ Basting: Page 56
◆ Symmetrical pattern: Page 57
◆ Programming while entering splits in different
◆ Zigzag stitch: Page 59
5. Press
6. Repeat steps 4 and 5 to move the cursor to C.
7. Press
8. Carry out steps 5 and after in "Programming
procedure" (page 18).
to B.
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
m p l e
m p l e
patterns: Page 58
.
.
51