Setting The Programming Functions - Brother BAS H Series Instruction Manual

CHAPTER 6 SETTING FUNCTIONS
You can change the settings which relate to programming functions.
The changed settings will be applied when programming.
The procedure for changing the programmer settings and the items which can be set are explained below.
1. At the screen, touch
2. Touch to display the programmer settings.
3. Touch the setting value for the setting item which you would like to change, and then change the setting value.
* Refer to the following table for the setting items.
4. Touch at the bottom of the screen to apply the changed settings.
Setting item Summary
Jog acceleration This changes the acceleration pattern for the jog key when it is held
pattern
down.
ON: When entering data, it is automatically connected to the end point of
Continuous data input
OFF: When entering data, an outline start point is entered each time.
X coordinate initial
Changes the initial value for the cursor's X coordinate.
value (mm)
Y coordinate initial
Changes the initial value for the cursor's Y coordinate.
value (mm)
ON: When checking sewing points, the option output signal turns on and
Option output when
off according to the settings for option output codes 1, 2 and 3.
checking sewing points
OFF: The option output signal is not turned on and off.
ON: The roles of the
Switching the home
when the Programmer screen is displayed.
key and enter key
OFF: The roles of the
ON: A marker is displayed at a fixed distance from the cursor
Programmer screen.
Marker display
OFF: A marker is not displayed.
Marker X display
position (movement
Changes the X coordinate of the marker's display position.
amount from cursor)
(mm)
Marker Y display
position (movement
Changes the Y coordinate of the marker's display position.
amount from cursor)
(mm)
ON: At the Home screen, touch
editing screen.
Starting extended
option editing directly
OFF: At the Home screen, touch
screen.
ON: A single SEQ file is always used for extended option editing.
OFF: Settings are saved in multiple SEQ files specified by numbers for
Single SEQ file mode
extended option editing.
126
S e t t i n g t h e p r o g
S e t t i n g t h e p r o g
.
the previous outline.
key and the
key and the
BAS H series, Programmer
r a m m i n g f u n c t i o n
r a m m i n g f u n c t i o n
key are switched, only
key are not switched.
to display the extended option
to display the programming
s
s
Setting value
1 - 5
Slow ... Fast
ON ／ OFF
－ 999 - 999
－ 999 - 999
ON ／ OFF
ON ／ OFF
in the
ON ／ OFF
－ 999 - 999
－ 999 - 999
ON ／ OFF
ON ／ OFF