Continuous Sewing With The Work Clamp In Position After Thread Trimming (Feed); Continuous Sewing With The Work Clamp In Position After Thread Trimming(Feed) - Brother BAS H Series Instruction Manual

Continuous sewing with the work clamp in position after thread trimming (feed)

Set "feed" to continue sewing with the work clamp in position after thread trimming.
The following describes how to program pattern 2 with a feed after pattern 1.
Pattern 1
1. Carry out steps 1 to 3 in "Programming procedure"
(page 17).
2. Create the outline for pattern 1.
* Refer to "Pattern with lines" (page 52).
3. Touch .
4. Touch .
Pattern 2
5. Use the jog key to move the cursor
6. Press
7. Create the outline for pattern 2.
8. Carry out steps 5 and after in "Programming
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
twice.
* Refer to "Pattern with lines" (page 52).
procedure" (page 18).
to C.
55