Adding A New Sewing Start Point Before The First Stitch - Brother BAS H Series Instruction Manual

Adding a new sewing start point before the first stitch

A point is added before the current sewing start point to make it as the sewing start point.
The following describes how to change the sewing start point from 1 to 1'.
1. Carry out step 8 in "Programming procedure" (page
20).
2. Touch .
3. Touch .
4. Touch to select "Add Automatically".
5. Use to move the cursor
6. Press .
*You can move the cursor according to the skipping
units.
* You can move the cursor continuously by holding
down the key.
A sewing point will be added to the outline between
sewing points 1 and 2.
Added point
7. Touch
8. Touch
9. Use
10. When you press the
will change to red and it will be selected.
11. Press
12. Use the jog key to move the cursor
to 1.
13. Press
14. Repeat steps 9 to 13 to move the sewing point which
was added in step 6 to position 1.
15. Carry out steps 6 and 7 in "Programming procedure"
(page 19, 20).
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
.
to select "Manual select".
to move the cursor
key once, the sewing point
.
.
The 1 at the 1st stitch will move, and the needle
position for the sewing start point will move to 1'.
to 1.
to 1'.
65