Modifying A Pattern By Moving A Component Point - Brother BAS H Series Instruction Manual

Modifying a pattern by moving a component point

This section describes how to change the outline component points in a pattern which has already been programmed.
This section describes how to modify a circle (A, B and C) so that it passes through the vertices of a triangle (D, E and
F), using an actual program as an example.
E
B
C
A
F
D
1. Carry out step 8 in "Programming procedure"
(page 20).
2. Touch .
3. Touch .
4. Touch to select "Manual select".
5. Use to move the cursor
* You can move the cursor continuously by
holding down the key.
6. When you press the
point will change to red and it will be selected.
7. Press .
A,D
to A.
key once, the component
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
B,E
C,F
8. Use the jog key to move the cursor
9. Press .
Point A will move to position D.
E
B
A,D
10. Repeat steps 8 and 9 to move B to E and C to F.
B,E
A,D
11. Carry out steps 6 and 7 in "Programming
procedure" (page 19, 20).
to D.
C
F
C,F
67