Copying An Outline; Rotating An Outline - Brother BAS H Series Instruction Manual

CHAPTER 3 PROGRAMMING PATTERNS

Copying an outline

1. Touch .
2. Touch .
3. Use to position the cursor
which you would like to copy.
4. When you press the
change to red lines and it will be selected.
When you press the
outline will be unselected.

Rotating an outline

1. Touch .
2. Touch .
3. Use to position the cursor
which you would like to rotate.
4. When you press the
change to red lines and it will be selected.
When you press the
outline will be unselected.
5. If there is more than one outline that you would like to
rotate, repeat steps 3 and 4.
* To select all outlines
Hold down to select all outlines.
30
at the outline
key once, the outline will
key once, the selected
at the outline
key once, the outline will
key once, the selected
BAS H series, Programmer
5. If there is more than one outline that you would like to
copy, repeat steps 3 and 4.
* To select all outlines
Hold down to select all outlines.
* To unselect all outlines
Hold down to unselect all selected outlines.
6. Press .
7. Touch to set the method for moving the cursor
(Move freely, Snap to needle point).
8. Use the jog key to move the cursor
where you would like to copy the outline.
9. Press .
* To unselect all outlines
Hold down to unselect all selected outlines.
6. Touch to set the rotation angle, rotation
center point and method for moving the cursor (Move
freely, Snap to needle point).
* Rotation center ... Origin, Center of Mask, Mask top edge,
Mask bottom edge, Mask top-left, Mask bottom-left, Mask
top-right, Mask bottom-right, Specified point
* The method for moving the cursor is set only when the rotation
center point is set to "Specified point".
7. Press .
* If the rotation center was set to "Specified point" in
step 6, you can use the jog key to move the cursor
so that the current cursor position rotates around
the center.
In this case, after moving the cursor
once more. In addition, each time you change
the rotation angle, the preview is displayed after the
outline is rotated.
Method for moving the
cursor
to the place
Rotation angle
Rotation center point
, press