Brother BAS H Series Instruction Manual page 103

 Using trigger data to turn the output on while sewing
In the "Individually programming on and off" example, No. 15 was programmed to turn on at the sewing start point. In
this example, the setting is changed so that it turns on during sewing. Do not change the off setting at the sewing start
which was set in the "Individually programming on and off" example.
1. Touch .
Load the programs which have already been written.
2. Referring to the table of sewing machine operation mode condition numbers (refer to page 85), set "ON when
condition No. 14 (trigger data detection) is established".
On the setting screen, overwrite the values as follows.
Check that the data which was set in "Individually programming on and off" still remains.
3. Touch to overwrite the extended option output.
4. Display the extended option output settings once more.
Touch to apply the extended option output which was overwritten in step 3 to the sewing machine.
5. Load the sewing program for editing, and add a code at the desired position. ("Adding and deleting codes at sewing
points" in "Chapter 3 - Programming with icons" (page 47))
At the code editing screen, specify "Not paused" for option output No. 15. Enter into the setting screen as follows.
6. After adding the code, save the sewing program under a new program number.
7. Carry out sewing.
Check that the left work clamp rises at the position where the code was added, and that it drops when sewing starts.
CHAPTER 4 EXTENDED OPTION OUTPUT (PROGRAM)
BAS H series, Programmer
95